P80 Slide Sticking - On my g26 build the trigger works and resets fine, but when you pull the slide all the way to the rear it gets stuck just a tiny bit before the slide stop would catch in its notch. You can try to. Check the firing pin safety in the slide. If it is binding you can have all sorts of trigger and slide problems. The plunger seems to be moving freely in its bore when moved by hand. The slide release spring should curve around the end of the slide release and arc upwards. The end of the spring should stick out towards the rear. You should see the tip. It appears the shelf. It's most likely your barrel doesn't like your slide. Take your barrel and slide off and drop the barrel in with no recoil spring. Does it fit easily into battery with the slide/ barrel hood flush. I’ve currently built a p80 g17 with both the frame and slide completed. However, i’m having some trouble getting the slide to go on correctly. When i attach the slide to the. I’m having a problem racking my slide all the way back. The slide starts off normal then at a certain point it gets rough and hard, seems like the slide is angling down into the polymer80. I just finished assembling my first p80 g19. I checked the trigger reset, and it seemed fine. I went ahead to disassembly the slide first by pulling the trigger, depress the. Mine seemed to get hung up but if i put a little pressure on the rear of the slide it would fall the rest of the way. Problem fixed itself after a thorough oiling, racking and dry fire, then like 50rds,. I had similar issues, back plate rubbed and bound on the trigger housing when the slide went back (wouldn’t go back to battery and i had to strip to unstick it), and the slide and. I had a lower on which i could test my zaffiri zps. edc slide. When i pulled the slide all the way back, about half the time, it would stick there. The slide was getting hung up.
On my g26 build the trigger works and resets fine, but when you pull the slide all the way to the rear it gets stuck just a tiny bit before the slide stop would catch in its notch. You can try to. Check the firing pin safety in the slide. If it is binding you can have all sorts of trigger and slide problems. The plunger seems to be moving freely in its bore when moved by hand. The slide release spring should curve around the end of the slide release and arc upwards. The end of the spring should stick out towards the rear. You should see the tip. It appears the shelf. It's most likely your barrel doesn't like your slide. Take your barrel and slide off and drop the barrel in with no recoil spring. Does it fit easily into battery with the slide/ barrel hood flush. I’ve currently built a p80 g17 with both the frame and slide completed. However, i’m having some trouble getting the slide to go on correctly. When i attach the slide to the.